Product Maintenance - Fellowes Powershred 1800C Manual Del Usuario

BASIC SHREDDING OPERATION
Continuous operation:
Up to 30 minutes maximum
NOTE: Shredder runs briefly after each pass to clear
entry. Continuous operation beyond 30 minutes will
trigger 50-minute cool down period.
ADVANCED PRODUCT FEATURES
Auto Reverse
Stops and reverses paper
if a jam occurs.
SLEEP MODE OPERATION
Energy saving feature shuts down the shredder after
2 minutes of inactivity.
WHEN IN SLEEP MODE
1
In sleep mode
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
* Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This
indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
Bin Open Indicator: The shredder will not run if the cabinet bin is open. When illuminated, close the bin to resume shredding.
Bin Full: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36052.
Remove Paper: When illuminated, press reverse ( ) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.
PAPER, CARD or CD
2
1 1
Plug in and put Feed paper straight
disconnect power switch into paper entry
in ON (I) position and release
Sleep Mode
Energy saving feature shuts down
the shredder after 2 minutes
of inactivity.
2
insert paper
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off ( )
3 4
or
Hold card/CD at edge.
When finished
Feed into center of
shredding set to
entry and release
OFF ( ))
SilentShred™ Technology
Shreds without noisy disruptions.
2 3
*Apply oil across entry Press and hold forward
( ) 2-3 seconds
3