Usage - ALFRA AMT150 Instrucciones De Operación

Usage

1. In order to adjust the assembly table to the length of
adjust the assembly table to the length of
the mounting plate, wind the work surface into the the mounting plate, wind the work surface into the
horizontal position. Remove the split ontal position. Remove the split rivet (1) on the
lower pull-out part. Afterwards, loosen the locking out part. Afterwards, loosen the locking
screws (2) and adjust to the desired length. and adjust to the desired length.
Now the locking screws are to be tightened again locking screws are to be tightened again
and the split rivet re-inserted.
On the upper pull-out part only the two locking
screws have to be loosened to set the desired screws have to be loosened to set the desired
length. Afterwards the locking screws should be length. Afterwards the locking screws should be
tightened again and the work surface is set to the tightened again and the work surface is
length of the mounting plate.
Now place the mounting plates on the work surface. Now place the mounting plates on the work surface.
2. In order to set the lower pull In order to set the lower pull-out part to the width of
the mounting plate, the work surface must be in the the mounting plate, the work surface must be in the
horizontal position. Loosen the clamping lever (3) horizontal position. Loosen the clamping lever
and adjust the adapter plates to the desired width. and adjust the adapter plates to the desired width.
The adapter plates must be positioned in such a The adapter plates must be positioned in such a
way that the screwed-in knurled thumb screw fits
tightly on the inner side of the mounting plate's U- tightly on the inner side of the mounting plate's U
section. section. After adjusting the width, tighten the After adjusting the width, tighten the
clamping lever again. Now screw in the knurled
thumb screws.
3. In order to set the upper pull In order to set the upper pull-out part to the width of
the mounting plate, the work surface must be in the the mounting plate, the work surface must be in the
horizontal position. Loosen the clamping lever (3) horizontal position. Loosen the clamping lever
and adjust the adapter plates to the desired width.
The adapter plates must be positioned in such a The adapter plates must be positioned in such a
way that the retracted stop bolts way that the retracted stop bolts (4) fit tightly on the
inner side of the mounting plate's U-section. After inner side of the mounting plate's U
adjusting the width, tighten the clamping lever adjusting the width, tighten the clamping lever (3)
again.
In order to fix the mounting plate, pull the stop bolts to fix the mounting plate, pull the stop bolts
(4) back and turn the lever to the left. The stop bolt back and turn the lever to the left. The stop bolt
is now retracted. Now attach the mounting plate and is now retracted. Now attach the mounting plate and
turn the stop bolt back again. The stop bolts will be turn the stop bolt back again. The stop bolts will be
extended and the mounting plate is fixed. extended and the mounting plate is fixed.
inserted.
out part only the two locking
in knurled thumb screw fits
again. Now screw in the knurled
lates to the desired width.
9