Programming An Intercom Group; Disabling The Intercom Function - Motostar LIVIMN-B-N Manual De Instalación

Programming an intercom group

y
Programming an intercommunicating group must be carried out AFTER assigning the call key to all of the receivers.
A
2
3
M1
4

Disabling the intercom function

M1
1
M1
2
Assigning intercommunicating groups
>8''
With the SW3 jumper inserted, press the PROG key for at least 8 seconds and release
<11''
it (within 11 seconds) 1 as soon as the PROG LED flashes and the key back lighting
PROG
comes on 2.
To enable the intercom function, go to the receiver that you want to programme, and
press the intercom call key you want to call from: a beep will sound to show that
SW3
programming has taken place 3. Repeat for all receivers to be included in the inter-
communicating group.
At the end, briefly press the PROG key 4.
NOTE: If no action is performed, the procedure will end automatically after 30
PROG
minutes.
SW3
y
3 beep
signing the intercom call button, it cannot be excluded from this group. If you
want to change the intercom call button on a receiver which has already been
programmed as an intercommunicating receiver, or you want to add new receiv-
ers to the group, repeat the operations detailed under "Programming an inter-
communicating group".
<1''
PROG
SW3
M2
To deactivate the intercom function, you simply have to disconnect the SW3 jumper 1;
by doing this, programming of the intercom system is also inhibited.
PROG
To reactivate this function you must restore factory settings.
SW3
M2
PROG
SW3
M2
Once a receiver has been included in an intercommunicating group by as-