Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION
STEP
5
Hang the Opener
Two representatLve installations are shown. Yours
may be different. Hanging brackets should be angled
(Figure 1) to provide rigid support. On finished
ceilings (Figure 2), attach a sturdy metal bracket to
structural supports before installing the opener. This
bracket and fastening hardware are not provided.
(See Accessories.)
To avoid possibleSERIOUS INJURYfrom a falling
garagedoor opener,fasten it SECURELY t o structural
supports of the garage.Concreteanchors MUSTbe used
if installingany brackets into masonry.
Figure 1
Str'Jctural
1. Measure the distance from each side of the motor
unit to the structural support.
2, Cut both pieces of the hanging bracket to required
lengths.
3. Drill 3/16" pilot holes in the structural supports.
4. Attach one end of each bracket to a support with
5/16"-18xl-7/8" lag screws.
5. Fasten the opener to the hanging brackets with
5/16"-18x7/8" hex screws, lock washers and nuts.
6. Check to make sure the rail is centered over the
door (or in line with the header bracket if the
bracket is not centered above the door).
7. Remove the 2x4. Operate the door manually. If
the door hits the rail, raise the header bracket.
NOTE: Do NOT connect power to opener at this
time.
HARDWARESHOWNACTUALSIZE
Ll,l llLlllltI,LIlllll.
Lag Screw
5116"-18x1-7/8"
5/16"- 18x7/8"
Nut 5/16"-18
Lock Washer 5/16"
Measure
\,
Distance
',
Lag Screws
5/16"-18xl-7/8"
5/16"-!8×718"Screw
5/16" Lock Washer
5/16"-18 Nut
Figure 2
Hidden
..-
.-_
5/16"-18xl-718"
_.-
Bracket
--_
(NotProvided)
(Not Provided)_-
_ . .-
:::..-"_'_
_._._J
_
5/16"-18x7/e" Screw
"'_
5/16" Lock Washer
"--
5/16"-18 Nut
5/16"-18x718"$crew
5/165/16"
Lock
Washer18_i_,
.TI::]_ !_;'_'
17
Capítulos
Tabla de contenido
