Tabla de contenido
Idiomas disponibles
Idiomas disponibles
GB
NOTE: When power is switched on, the pump will activate immediately.
Overheating
•
Should the pump overheat, it will automatically cut out.
•
Once the thermal overload switch has cooled down (after approx. 10
mins), it will reset and automatically switch on.
•
The possible cause may be due to an obstruction.
De-aeration
•
The pump is equipped with an automatic de-aeration device that will
remove air locks that could form in the pump.
•
If the pump is allowed to draw off water to the bottom of the unit, the
pump will have sucked in air, affecting its performance until it is able to
de-aerate.
•
Should this oocur, disconnect the pump from the mains power.
•
The de-aeration process will only be possible once the water level has
risen above the bottom of the pump i.e. when it is no longer able to
suck in air.
•
The power needs to remain off for a minimum of one minute, then it can
be reconnected, when the pump will automatically de-aerate.
Maintenance
Cleaning the filter
The following is the only maintenance that should be carried out by the
end user:
•
If the pump is dismantled to any degree other than as described below,
any claim will be invalidated under warranty.
WARNING: Disconnect the pump from the mains supply before undertaking
this work.
•
In the event that the suction base (3) becomes blocked, remove the 4
crosshead screws from the suction base that will release the base from
the body of the pump.
•
Check for any obstructions within the exposed area i.e. small stones or
gravel. it is suggested you also rinse this area of the base and the mesh
filter with clean water before re-assembling the base. If used to pump
chlorinated water or any liquid with residues, the pump should be rinsed
after use with clean water.
WARNING: Disconnect the product from the mains supply BEFORE any such
work is undertaken. When not in use, protect the pump from frost damage
and store in a dry place. No further disassembly should be undertaken.
Disposal
•
Do not dispose of power tools, or other waste electrical and electronic
equipment, with household waste.
•
Contact your local waste disposal authority for information on the proper
way to dispose of tools.
6
Tabla de contenido
