Prepare The Site - KALLISTA P74000 Guia De Instalacion

Wall Bracing
(2x6 minimum)
C L
Finished
Floor

1. Prepare the Site

Rough-in the water supply lines and the drain piping.
Install a minimum of a 2x6 as a wall brace to provide support for
the wall bracket. The brace should be the same length as the
console table, 36" (91.4 cm) and should be positioned 34"
(86.4 cm) from the finished floor to the top edge of the board. The
center of the wall brace should be in-line with the drain outlet.
Finish the wall.
Mark the centerline on the floor and the wall.
Mark the anchor holes for the console table mounting bracket on
the wall by holding the bracket up to the finished wall so that the
center of the bracket lines up with the centerline. Mark the
location of the anchor holes with a pencil.
Mark the location of the holes on the floor for the feet anchors.
Drill two holes 5/16" D. (8 mm) x 1/2" (1.3 cm) deep, in the
finished floor for each foot anchor. The holes should be 19-1/4"
(48.9 cm) from the wall and 15-1/4" (38.7 cm) from the centerline.
Kallista
Finished
Wall
Console Table
Bracket Anchor
Holes
34"
(86.4 cm)
Foot Anchor
Holes
19-1/4"
(48.9 cm)
3
Mark the
anchor holes.
C L
15-1/4"
(38.7 cm)
1008424-2-A