Specifications - RocketFish RF-WHP01 Guia Del Usuario

Auriculares estéreo digitales inalámbricos
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

08-1077 RF-WHP01-WHP02.book Page 24 Thursday, March 27, 2008 1:29 PM
Problem
Solution
Sound interference
No communication
between the
headphones and
docking station
WHP02: The headphones and docking station power indicators light up after the
headphone switch is set to ON and AUX IN/MIC IN is set on the docking system.
WHP01: The headphones and docking station power indicators light up after the
headphone switch is set to ON and the
pressed.
Note: Try pressing the CONNECT button again if the LED indicators keep blinking
after 30 seconds.

Specifications

Speaker
Impedance
Headphone type
Headband
Wireless type
Distance
Speaker input power 10 mW / 30 mW
24
• Move the docking station slowly to find the best reception position for your
headphones.
• Shorten the distance between your headphones and the docking station.
The maximum distance is 98 feet (WHP02) or 65 feet (WHP01).
• Check if there are any obvious radio frequency interference sources near
your system.
• Make sure that the AC adapter is connected to the docking station.
• Check if the two supplied batteries are installed into the headphone battery
compartments.
• Check if one or both batteries are exhausted.
• If they are lit green solidly, then a communication link has been successfully
established between the system.
• If they are blinking green on one, or both units, then press and hold the
CONNECT button on the headphones and docking station for three seconds
consecutively. (The headphones' CONNECT button is on the left earpiece
and the docking station's CONNECT button is on its back.) This puts the
system into the "connection mode" for about 30 seconds. The system
proceeds with the connection process between the headphones and
docking station. While in "connection mode", the LED indicators of
headphones and docking station blink between red and green alternatively.
When an active link is established between the headphones and docking
station, the LED indicators are solid on and will not blink.
40 mm Ferrite
32 ohm
Circumaural
Auto Adjusting Headband
2.4 Ghz ISM band
98 feet (30 m) line-of-sight (WHP02)
65 feet (20 m) line-of-sight (WHP01)
/| button on the docking system is
Tabla de contenido
loading

Este manual también es adecuado para:

Rf-whp02

Tabla de contenido