ENGLISH
CLEANING THE UNIT (Continued)
YOU MAY find a need to remove and clean the stainless grinding cage from the inside
base of the tank (trapped citrus pulp, etc.) Refer to the directions below to perform this
function.
REMOVING AND SETTING THE STAINLESS GRINDING CAGE
IT IS VERY IMPORTANT THAT THIS THE STAINLESS STEEL GRINDING CAGE IS
ASSEMBLED PROPERLY FOR YOUR UNIT TO WORK.
1.
Inside the unit is a stainless steel grinding cage
and round plastic collar to lock the grinding cage into
place**.
2.
Place the stainless steel grinding cage with the
smooth side (opposite of the 3 tab side) into the
plastic collar and twist until the notch of the stainless
steel grinding cage locks into the protrusion on the
plastic collar. (See illustration H).
3.
Turn the assembled grinding cage (with plastic cover) over, so black plastic collar is
on the top to insert into the base of tank.
4.
Looking down into the interior of the tank, you will see 2
Stainless Steel screws. This is where the clips attached
to the plastic collar lock the grinding mechanism down.
(Illustration H)
5.
When putting the collar into position, align the plastic
collar with the tabs with the indented postpositions. With
firm but gentle pressure, press the collar down until the
tabs "click" into place.
6.
Once everything is in place, make sure the clips are pushed inward toward the
screws to lock the unit into position, (Illustration H) and lift slightly to insure the cage
is in fact locked into position properly and will not release.
**THIS IS VERY IMPORTANT! IF THE COLLAR IS NOT LOCKED PROPERLY - THE
UNIT WILL GRIND BUT WILL NOT DISPENSE. Lock and unlock clips carefully, to
avoid breaking. Your MARGARATOR™ is now ready to fill with your favorite liquid and
use again.
IMPORTANT:
DO NOT PUT TANK IN DISHWASHER!
5
G
H