Minebea Intec YDO01M-232 Instrucciones De Instalación página 4

Installation in the Display and Control Unit
YDO01M
4
Installation in the Display and Control Unit
Installation
Installation of the interface module in the Midrics display and control unit (and addi-
tionally the installation of the cable gland and connection of the connecting cable to
the terminal screw strip) is only required if the Midrics display and control unit was not
equipped at the factory with this data output in accordance with the customer's order.
Notes:
§ The interface module should be installed by a certified technician who has received
specialized training from Minebea Intec .
§ IP65 protection:
Make sure to use the connecting cable with screw-lock hardware designed for the inter-
face module in question (see "Accessories").
! Make sure to disconnect the equipment from power before beginning installation.
! Any installation work that does not conform to the instructions in this manual will result
in forfeiture of all claims under the manufacturer's warranty.
Installation work that affects the IP65 protection rating must be performed with extreme
!
care.
The cable gland (IP65 protection) for connection of the interface to the display and con-
trol unit is covered by a protective cap. Please use extreme caution when performing any
work on the equipment that affects this cable gland.
§ To open the display and control unit, remove the screws from the front panel.
Installing the COM1 PCB:
§ Remove fastening screw.