12400 Earl Jones Way, Louisville, KY 40299
(800) 626-1126 | www.rev-a-shelf.com
TOOLS REQUIRED:
5/16"-18
17/64"
Warning: It is recommended that this procedure be done by a skilled machinist. The locations of
the holes are critical and the tolerance on their location is +/- 1/32". The holes must be tapped
exactly perpendicular to the arm.
To install dampener onto an existing Mixer Lift, you have to drill and tap (2) 5/16"-18 holes on the arms.
1) On the top arm (rounded end), measure 3-11/32" from bottom and place mark at the center of arm.
2) On the bottom arm (flat end), measure 7-5/8" from bottom and place mark at the center of arm.
3) With the unit in the open position, drill 17/64" diameter hole in the top arm and tap with 5/16"-18 tap.
4) Close the unit and drill 17/64" diameter hole in the bottom arm and tap with 5/16"-18 tap.
5) Follow steps 1-4 on other arm assembly.
6) Follow directions on pages 1-2 to install dampener kit.
ESTIMATED ASSEMBLY
TIME:
30 MIN
FOR EXISTING MIXER LIFT
DRILL-AND-TAP
3
INSTALLATION
INSTRUCTIONS
CARE AND MAINTENANCE:
CLEAN WITH A DAMP CLOTH
AND WIPE PARTS DRY.
Top Arm
Bottom Arm
SOFT-CLOSE
MIXER LIFT DAMPENER
(OPEN POSITION)
I-MLHDSC-TRI-0415
