Spare Parts; Installing Wings With Ailerons - Carson SKYDREAMER GLIDER Manual De Instrucciones

SPARE PARTS

GB GB
The following replacement and spare parts are
available for the Skydreamer
50 050 8308
Wing-Set
50 050 8307
Cockpit hood
50 050 8306
Two-piece
fuselage
AILERON CONVERSION KIT Product No. 50 050 8305
The Skydreamer can be converted using the
Aileron Conversion Kit on wings with functioning
ailerons, which is of particular interest to
experienced model fliers. This makes controllability
more versatile and more precise; however the
added function does require more attention during
operation.
The conversion kit contains the left and right wing
each with a ready built-in microservo and cable of
appropriate length. Procedure for fitting:
- Do not push the wings fully onto the carbon
spar.
- Feed both servo cables through to the receiver
- Finally push the wings into the fuselage.
- Push the plug servo cable plug firmly into the Y
cable.
- Plug the Y cable into slot 4 of the receiver,
checking for the correct direction.
- Check for correct operation; if the aileron
moves in the wrong direction change the servo
reverse switch for channel 4.
20 SKYDREAMER CARSON R/C MODEL AIRCRAFT 50 050 5011
The use and fitting of accessories is described
elsewhere.
50 050 8018
Flight controller
"Turbine" 15A
50 050 8311
Propeller-Set
50 050 8019
Elektric Motor
Type 380 Turbine 1
50 050 2001
CM-1 Servo
50 050 8312
Decal sheet Skydreamer
View fron below
Servo
connector
Aileron downwards
50 050 8310
Rudder
50 050 8309
Elevator
50 060 8063
Flight battery Skydreamer
NiMH 9,6V 950mAh
Servo
connector
Y-cable
View from behind
in flight direction
during a right turn
Aileron upwards