EDM Product 08702 Manual De Instrucciones página 13

5. Cutting thin wall tubes and small size metal materials.
CAUTION!
Never cover air vents. They must always be open for proper
motor cooling.
To start your grinder:
1. Plug the cordset into a power socket;
2. Push the Lock-off Catch on the trigger switch forward;
3. Pull on the trigger switch.
To stop your grinder:
1. Release the on/off switch.
For Proper Operations
1. Before starting the grinder, put on safety glasses and make
sure that the grinding wheel, guard and the tool are in good
condition and correctly fitted.
2. Always hold the tool firmly with one hand on the rear
handle and the other on the side handle.
3. Turn the angle grinder on and then apply the grinding
wheel to the workpiece.
4. In general, keep the edge of the wheel at an angle of about
30°for roughing and about 15 for finishing.
5. Move the grinder back and forth or up and down over the
work area.
6. Use just enough pressure to keep the grinder from
chattering or bouncing.
7. Avoid overloading the tool for a long time, heavy pressure
will decrease its speed and put a strain on the motor .
8. Lift the grinder away from the workpiece before turning
your grinder off.
WARNING!
Never use your grinder without wearing eye protection.
Following this rule will reduce the risk of serious personal
injury.
DANGER!
Never attach a wood cutting or carving blade of any type to
this angle grinder.
Never use your grinder with guard removed.
Failure to follow this rule could result in serious personal
injury.
WARNING!
If any of the following events occurs during normal operation,
the power supply should be shut off immediately and then
the tool should be inspected thoroughly and repaired by a
qualified person and repaired it if necessary:
The rotating parts get stuck or speed drops abnormally low.
The tool shakes abnormally and accompanied by some
unusual noise.
The motor housing gets abnormally hot.
Heavy sparks occurring around the motor area.
EN INSTRUCTION MANUAL
ANGLE GRINDER
MAINTENANCE
WARNING!
Maintenance and repair work should only be done by a
qualified service technician. When servicing a tool, it's
recommended to use only spare parts provided by the
manufacturer of the tool.
Preventive maintenance
personnel may result in misplacing of internal wires and
components which could cause serious hazard.
CAUTION !
Always be sure that the tool is switched off and unplugged
before attempting to perform inspection or maintenance.
Regularly clean the tool's air vents with compressed dry air.
do not attempt to clean by inserting pointed objects through
openings.
CAUTION!
Certain cleaning agents and solvents may damage plastic
parts. Some of these are: gasoline, carbon tetrachloride,
chlorinated cleaning solvents, ammonia and household
detergents that contain ammonia.
To ensure safe use and maximize service life of your tool,
following instructions should be observed:
Regularly inspect the grinding wheel----ensure that the
grinding wheel is free of cracks and surface defects. Replace
the grinding wheel when it has worn out.
Regularly inspect all mounting screws and ensure that they
are properly tightened.
Regularly clean the air vents of the tool.
Check and replace carbon brushes when necessary. When it's
necessary, peel off the labels on both sides of the tool.
Remove the carbon brush caps with screwdriver. Pull out the
carbon brushes for inspection. If the brushes are worn out,
they should be replaced with a new pair of brushes. Note that
the brushes must be replaced in pair. Make sure the brush
can be slided freely inside the brush holder. Put back the
brush caps and tighten them with screws. Be careful not to
overtighten the screws.
ACCESSORIES
Spanner
Auxiliary handle
Instruction manual
REF. 08702
performed by unauthorized