Operation; Before Starting; Fuel Recommendations - Snapper NXT ENXT22875E Manual Del Operador

Operation

Before Starting

1. Check the guards, deflectors, grass bag, and covers to
make sure all are in place and securely tightened.
2. Check the blade control (A, Figure 4) and drive control
(B) to insure they work freely.
A
Figure 4: Mower controls
3. Check the cutting height. Adjust to the desired height.
Refer to the section entitled 'Cutting Height Adjustment'.
4. Check the engine oil:
• Make sure the mower is on a level surface.
• Clean the oil fill area of any debris.
• Remove the dipstick (A, Figure 5) and wipe with a
clean cloth.
• Insert and tighten the dipstick.
• Remove the dipstick and check the oil level. It should
be at the top of the full indicator (B) on the dipstick.
• If low, add oil (Briggs & Stratton warranty-certified
SAE30 lawnmower oil is recommended) slowly into the
engine oil fill. Do not overfill. After adding oil, wait one
minute and recheck the oil level.
• Replace and tighten the dipstick.
A
Figure 5: Oil and fuel fill
IMPORTANT Mower is shipped without oil in engine.
Failure to add oil before starting will result in engine
damage.
10
B
B
C
D
5. Add fuel to the tank:
• Make sure the mower is outside, where fumes can
safely dissipate.
• Remove the fuel fill cap (C, Figure 5).
• Fill the tank with fuel. Refer to the section entitled 'Fuel
Recommendations'. To allow for expansion of the fuel,
do not fill above the bottom of the filler neck (D).
• Reinstall the fuel fill cap.
6. Clean the exterior surfaces of the cutting deck and
engine of any accumulation of spilled fuel, dirt, grass,
oil, etc. Keep the engine air intake screen and cooling
fins clear at all times.
7. Charge the battery. Refer to the section entitled
"Charging the Battery".

Fuel Recommendations

Fuel must meet these requirements:
• Clean, fresh, unleaded gasoline with
• A minimum of 87 octane / 87AKI (90 RON).
• Gasoline with up to 10% ethanol (gasahol) or up to 15%
MTBE (methyl tertiary butyl ether) is acceptable.
• CAUTION: DO NOT use unapproved gasoline, such as E85.
Do not mix oil in gasoline or modify the engine to run on
alternative fuels. This will damage the engine components
and void the engine warranty.
The engine on this equipment is certified to operate on
gasoline. The emissions control system for this engine is EM
(Engine Modifications).
High Altitude
At altitudes over 5,000 feet (1524 meters), a minimum 85
octane/85 AKI (89 RON) gasoline is acceptable. To remain
emissions compliant, high altitude adjustment is required.
Operation without this adjustment will cause decreased
performance, increased fuel consumption, and increased
emissions.
Operation of the engine at altitudes below 2,500 feet (762
meters) with the high altitude kit is not recommended.
www.snapper.com