Basic Setup - Bushnell BACKTRACK D-TOUR Manual De Instrucciones

BASIC SETUP

• Open battery cover and insert 3 AAA batteries (Fig 1,
pg 4). Record the serial # inside-you'll need it later to
register your D-Tour online. Close the cover.
• Go outdoors. HOLD POWER (1) (keep the button
pressed) until the display comes on. Wait for GPS
satellite lock (icon stops blinking) (11). This may take
a few minutes after the first power-up in a new area.
• Press SETUP (4). Press MARK (2), then press the TRIP
(3) or SETUP button to set the Hour for your area
(Fig. 2).
• Press MARK to return to the Setup screen. To set
clock, distance or temperature units (change to 24 hr,
meters, C) press SETUP to select, then press MARK to
toggle between settings (Fig. 3). Press POWER to exit
Setup screen.
MARKING/RETURNING to a LOCATION
• Press POWER to select one of five Location icons (6)
(Home, Car, Star, Flag, Target). While standing at the
Location you want to mark, HOLD MARK to save its
position in the D-Tour's memory (the display will
change as shown) (Fig. 4). You can now turn the
power off (HOLD POWER) and leave the location.
• To return to the location you marked, turn the D-Tour
on. Make sure the same icon you used to mark the
location is shown (if not, press POWER to select it).
The display indicates the direction and distance back
to the location (Fig. 5). Move in the direction of the
arrow, watching for the distance to decrease. When
you reach the location, the "Mark" icon will flash in the
center of the display.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
5