Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.
Using other electrical products such as headphones or speakers
operating on the same signal frequency (915MHz) may prevent
correct signal transmission and reception.
4.
Neighbors using electrical devices operating on the 915MHz signal
frequency can also cause interference.
Note: When the 915 MHz signal is received correctly, do not re-open the
battery cover of the Solar Clock, as the batteries may spring free from the
contacts and force a false reset. Should this happen accidentally then
reset all units (see "TO INSTALL / REPLACE BATTERY IN THE SOLAR
CLOCK" and "INITIAL SETUP" above) otherwise transmission problems
may occur.
The maximum transmission range is 330 feet (100 m) (TBA) from the
outdoor transmitter to the Solar Clock (in open space). However, this
depends on the surrounding environment and interference levels. If no
reception is possible despite the observation of these factors, all system
units have to be reset (see "TO INSTALL / REPLACE BATTERY IN THE
SOLAR CLOCK" and "INITIAL SETUP").
POSITIONING THE SOLAR CLOCK:
Before permanently mounting, ensure that the Solar Clock is able to
receive 915MHz signals from the desired location. In addition, the Solar
Clock should be placed in a bright environment for the rechargeable
batteries to be able to recharge.
There are two possible ways to mount the solar clock:
use of the foldable table stands, or
wall mounting
WALL MOUNTING
1.
Install a mounting screw (not included) into a
wall—leaving approximately 3/16 of an inch
(5mm) extended from the wall.
Place the Solar Clock onto the screw, using the
2.
hanging hole on the backside. Gently pull the
Solar Clock down to lock the screw into place.
Note: Always ensure that the Solar Clock locks onto
the screw before releasing.
7
Tabla de contenido
