Tabla de contenido
Idiomas disponibles
Idiomas disponibles
en
ENGLISH
5. Overview
See page 2.
1 Geared chuck
2 Additional handle
3 Rotation selector switch
4 Trigger
5 Lock button (continuous operation)
6. Initial Operation
Before plugging in the device, check that
the rated mains voltage and mains
frequency, as specified on the rating label,
match your power supply.
Always install an RCD with a maximum trip
current of 30 mA upstream.
6.1
Assembly of the additional handle
For safety reasons, always use the addi-
tional handle supplied.
Open the clamping ring by turning the additional
handle (2) anticlockwise. Push the additional
handle onto the collar of the machine. Advance the
additional handle until it can be twisted. Then pull it
back into position at the required angle and secure
tightly.
7. Use
7.1
Switching On and Off
To start the machine, press the trigger (4).
The speed can be changed by pressing in the
trigger.
For continuous operation, the trigger can be locked
with the lock button (5). To stop the machine, press
the trigger again.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine
with both hands using the handles provided,
stand in a safe position and concentrate.
7.2
Selecting the direction of rotation
Do not activate the rotation selector
switch (3) unless the motor has
completely stopped.
Selecting the direction of rotation:
R = clockwise
L = counter-clockwise
0 = Central position: transport lock setting
(switch-on lock)
7.3
Tool Change with Geared Chuck (1)
See illustrations A, page 2.
Opening the drill chuck: Open the geared chuck
with chuck key -1.
Clamping the tool: Insert tool -2- as far as possible
and, using the chuck key, evenly secure in all 3
bores -3.
8
7.4
Drill chuck with "Quick" change system
(for BE 75 Quick)
To remove: Push the interlock ring forward (a),
advance and pull off the chuck (b). (1)
To mount: (1) Push the interlock ring forward and
move the chuck as far as the limit stop on the drill
spindle.
8. Troubleshooting
If the trigger (4) cannot be depressed, check that
the direction of rotation selector switch (3) is fully set
to the R or L position.
9. Accessories
Use only genuine Metabo accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating instruc-
tions.
Fit accessories securely. Secure the machine if it is
operated in a bracket. Loss of control can cause
personal injury.
For a complete range of accessories, see
www.metabo.com or the main catalogue.
10. Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
If you have Metabo electrical tools that require
repairs, please contact your Metabo service centre.
For addresses see www.metabo.com.
You can download spare parts lists from
www.metabo.com.
11. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2012/
19/EU on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately and
handed in for environmentally compatible recycling.
12. Technical Specifications
Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
P
= Rated input
1
P
= Power output
2
n
*
= No-load speed
1
n
*
= Load speed
2
max. dia. =Max. solid drill diameter
b
= Chuck capacity
G
= Spindle thread
m
= Weight
D
= Collar diameter
Tabla de contenido
