Power Supply - Philips AJ 3130 Manual De Uso

1. Check if the power supply, as shown on the type plate
inside the battery compartment, corresponds to your local

power supply.

2. If your set is equipped with:
• a voltage selector - found on the back of the set
• a frequency selector - inside the battery compartment
adjust these selectors to match with your local mains
supply and frequency.
3. Connect the power plug into the wall outlet. The power
supply is now switched on and the numbers on the display
will start to flash. You will need to set the correct time.
4. To disconnect the set from the power supply completely,
withdraw the power plug from the wall outlet.
Standby power consumption: ..................................................3W
POWER BREAKDOWN BACKUP
When a power failure occurs the complete clock radio will be
switched off. When the power supply returns, the numbers on
the display will start to flash and you will need to reset the
correct time on the clock.
To retain the clock time and the set alarm time in the event of
an AC power failure or disconnection, insert a 9 volt battery,
type 6F22 (not supplied) into the battery compartment: this will
act as a power backup. However, the time will not be
illuminated on the clock display. Operation of the alarm and
radio are also excluded. For clarity, the battery backup is used
to retain the clock and alarm time only. As soon as the power
supply returns, the display will indicate the correct time.
1. Insert the battery into the battery compartment.
2. Connect the power plug to the wall outlet.
• Replace the battery once a year, or as often as necessary.
Batteries contain chemical substances, so they should be
disposed of properly.
POWER SUPPLY
7