Idiomas disponibles
Idiomas disponibles
2
Phillips Screwdriver
Trim Panel Tool
PROCEDURE STEPS:
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument
panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait
two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This
is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental
airbag deployment and possible serious or fatal injury.
1. Disconnect and isolate the battery negative cable.
2. Using trim stick C4755 or equivalent, loosen the
instrument panel trim (2) located right of the center
stack bezel enough to access the switch bank
retaining screw underneath.
3. Using trim stick C4755 or equivalent, remove the in
strument panel trim (1) located left of the center stack
bezel.
Feb 02, 2011
www.mopar.com
Tools Required
Power Outlet Remover
10246 or equivalent
Trim Stick C4755 or
equivalent (1)
Back Up Camera Harness Routing
Scan Tool
Wire Strippers
T20, T30 Torx® Driver
K6861161
