Be Cool atomic Manual Del Usuario página 45

the locking arms engage with a clicking noise on both
sides. The green safety button must now be visible on
both sides.
Pull the Release button and meanwhile push the child
seat towards the backrest firmly.
Shake the child seat to make sure it is safely attached
and re-check the green safety button to make sure
that both of them are completely green.
Pull out the Top tether and press the Tether strap re-
lease button to extend the strap until it is long enough
to hook the User-ready tether anchorage behind.
Hook the Tether strap hook onto the User-ready
anchorages. Check there maybe are 3 anchorages for
the hook, please find one in your favor.
Pull the Tether strap on another end back to tighten
the Top tether.
4 .3 Installation of Group II and it is
for the children whose weight between
15-25kg.
Before the installation, please take away the Harness
system of baby car seat.
IM 2093 ,00_ATOMIC.indd 45
Note: Removing the 5-point harness system and cover.
Having your child sit down in the child seat.
Pull out the vehicle seat belt and guide it in front of
your child to the vehicle seat buckle.
CAUTION! Do not twist the belt.
Engage the buckle tongue in the vehicle seat buckle
"CLICK".
Make sure the lap belt section is stretched as low as
possible over the child's hips, within the belt guides
at both
lower sides of child car seat. Guild the diagonal seat belt
section into the red belt holder of the headrest until it
lies completely in the belt holder and is not twisted. The
diagonal seat belt must cross midway between child's
shoulder and neck.
5
5 .1 Removing the 5-point harness
system and cover
Loosen the 5-point harness of the child seat as much
as possible. Open the storage box on the back side of
thechild seat.
EN
45
20/2/19 17:16