BADU EasyFit Eco VS Ficha Técnica página 23

Pos: 24 /Technische Dokumentation/Pumpendatenblatt/Motorsteuerung/Eco/Hinweis: Einschalten Motordrehzahl mit Handtaster @ 2\mod_1434606168188_370.docx @ 33335 @ @ 1
NOTICE
The motor speed is switched on using the manual button or
external switch contacts. The switch contacts and the assigned
speed are activated.
If the pump starts from a standstill, it starts up in priming mode
and subsequently with the selected fixed speed.
During running operation the pump is started up to the fixed speed
directly, without priming time.
If external control is not necessary, the cable ends need to be
insulated.
Pos: 25 /Technische Dokumentation/Allgemeine Module/####halbe Leerzeile #### @ 3\mod_1437024231169_0.docx @ 36332 @ @ 1
Pos: 26 /Technische Dokumentation/Pumpendatenblatt/Motorsteuerung/Eco/Hinweis: Einbau eines Strömungswächters @ 2\mod_1434606407438_370.docx @ 33366 @ @ 1
NOTICE
Installing a flow monitor in the circulation line is recommended so
that a failure message can be displayed. A lengthy interruption of
the bath water circulation can be prevented in this way.
Pos: 27 /Technische Dokumentation/Allgemeine Module/####halbe Leerzeile #### @ 3\mod_1437024231169_0.docx @ 36332 @ @ 1
Pos: 28 /Technische Dokumentation/Pumpendatenblatt/Motorsteuerung/Eco/Eco VS/Hinweis: Fehlfunktionen Motor @ 3\mod_1445492497651_370.docx @ 49366 @ @ 1
NOTICE
The following points must be observed in order to avoid motor
malfunctions:
– The control line should be correctly installed by a specialist.
Assembly parallel to power lines or their load should be
avoided.
– Should the control lines be extended, dangerous voltages
can occur at the digital input. These should be avoided with
isolation.
– The power cables for various inputs should not be connected
to the same supply line.
Pos: 29 /Technische Dokumentation/Allgemeine Module/#### Seitenumbruch #### @ 0\mod_1426069111812_0.docx @ 891 @ @ 1
11|2016 EN 23