Idiomas disponibles
Idiomas disponibles
1. Cleaning the eyepiece
a. Do not remove eyepiece (1) from eyepiece tube (2).
b. Clean only the outer surface, misting the lens with breath.
c. Dry by wiping with lens paper in circular movements, from centre, outwards. Do not wipe
lenses when dry, as they can easily be scratched.
2. Cleaning the objectives.
a. Do not remove the objectives (4) from the microscope.
b. Only clean the outer surface, dampening a soft cotton cloth slightly with Xylene then
drying the lens with the same cloth.
3. Cleaning the condenser.
a. Clean only the top lens surface using either of the above methods, as for the eyepiece,
or the objectives.
4. Cleaning the illuminator lens.
a. Use any of the above methods, as for eyepiece, or the objectives.
B. Electrical maintenance.
WARNING: FOR YOUR OWN SAFETY SWITCH OFF AND DISCONNECT THE MICROSCOPE
FROM ANY ELECTRICAL SOURCE, BEFORE ATTEMPTING ANY MAINTENANCE PROCEDURE
TO AVOID THE RISK OF ELECTROCUTION.
1. Changing the bulb
•
For the SFC-100FL
a. Unscrew the illuminator (16) in a clockwise direction. If the bulb has been used, make
sure that it has cooled down.
b. Carefully take hold of the bulb, push down, and turn ¼ in an anti-clockwise direction.
Release pressure and the bulb will be freed from the socket.
c. Insert new bulb by pushing down and turning 1/4 turn in a clockwise direction.
d. Clean bulb if it has been touched, as this could leave traces and affect the transmission
of light.
e. Screw down the illuminator.
•
For the SFC-100FL(H)
a. Lay the microscope down on its side taking extreme care, especially with the eyepiece
(1).
b. Completely unscrew the 4 screws indicated (Fig. 1).
c. Open the cap on the base.
d. With a cloth carefully take hold of the bulb and pull straight out of socket.
-6-
Fig.1
