Idiomas disponibles
Idiomas disponibles
EN
4
INSTALLATION OF THE ACTIVATED CARBON FILTER
Note: Please note that the extractor hood shown is only an example and does not
necessarily correspond to your specific model. The system is the same for all activated
carbon filters covered by this manual.
1. Please remove the interior of your cooker hood by removing the grease filters. These
are located at the bottom of the hood (see illustration above).
2. Inside the hood you will see the motor. This one has an air intake on the left and right
side.
3. Now place the activated carbon filters on the air inlets one after another and lock
them with a clockwise rotation. The filter will snap in and out audibly.
4. Close the interior of the cooker hood by reinserting the grease filters.
The extractor hood is now converted to recirculation mode. There is no special mode or
switch that needs to be activated.
How often should I change the filters?
Changing the filters depends on the frequency of use of the hood. As a general
guideline, they should be changed every 3 months if used regularly.
