Additional Safety Instructions; Use And Operation - Asist AE2V20B-202-BMC-1 Instrucciones De Uso

ADDITIONAL SAFETY INSTRUCTIONS

Please read these safety instructions before use and
keep them in a safe place.
! - This symbol indicates the risk of injury or damage
to the device.
! Failure to follow the instructions in this manual may
result in injury.
! The cordless drill / screwdriver (hereinafter referred
to as the cordless drill) complies with the applicable
technical regulations and standards.
! Do not use the tool, accessories or charger for
purposes other than those for which they are
designed.
! If in doubt, before drilling holes or screwing into the
wall, use a metal detector to check that electrical
cables, gas or water pipes are not routed where you
want to drill.
Safety instructions for battery and charger.
Read the operating instructions carefully before using
the battery and charger for the first time.
! 1. Verify that the electric current that is in the el.
network, is identical to the values indicated on the
battery charger.
! 2. Do not allow moisture, rain or splashing water to
reach the battery charging location.
! 3. Do not charge the battery when the temperature
is below 10 ° C or above 40 ° C. Charging the battery
in extreme temperatures may shorten its life.
! 4. A damaged battery that can no longer be charged
must be treated as hazardous waste. Do not dispose
of the battery in normal household waste, fire or
water.
! 5. Use only batteries and chargers approved by the
manufacturer for use with married equipment.
! 6. Keep the charger clean, free of dust and dirt.
! 7. Always remove the battery before repairing tools.
! 8. Cover the battery contacts to prevent a short
circuit.
! 9. Avoid the risk of explosion!
! 10. Do not smoke while the battery is being charged
or stored. Damaged batteries can leak explosive
gas - hydrogen, which can ignite from open flames
or sparks.
! 11. In case of fire, try to extinguish the fire with earth
or sand.
! 12. The battery and charger become slightly hot
during charging.
! Chemical hazard.
Do not open the battery pack. Protect the battery
from impact. If the accumulator electrolyte leaks,
skin contact must be avoided. If electrolyte contact
with the skin still occurs, rinse the affected area
immediately with water. If electrolyte gets into your
eyes, see a doctor immediately.
- Use protective equipment against noise, dust and
vibration !!!
SAVE THESE SAFETY INSTRUCTIONS !!!
DESCRIPTION
This cordless drill / screwdriver is designed for drilling
holes in wood, metal, masonry and screwdriving.
Do not use the tool, accessories or charger for any
purpose other than that for which they are designed!
All other uses are expressly prohibited.
1. Chuck
2. Torque control
3. Switch (trigger)
4. Direction of rotation switch
5. Battery / Li-ion / 2x
6, Battery release button
7. Charging device
8. ---
9. LED lighting
10. Speed switch
Accessories 2 x Battery, case
Pictograms
Pictograms on the product packaging:
a) Power supply
b) Idle speed
c) Chuck

USE AND OPERATION

ASIST tools are intended for home or hobby use only.
The manufacturer and importer do not recommend
using this tool in extreme conditions and under high
loads.
Any additional requirements must be the subject of
an agreement between the manufacturer and the
customer.
Inserting and removing the battery
1. Insert the charged battery into the tool handle and
secure with the release buttons.
Note: The release buttons are on both sides of the
battery. The spring must snap into place to secure
the battery.
2. Disconnect the battery from the tool handle by
pressing the release buttons and pulling it out of the
tool.
Charging (B)
Warning:
The battery must be charged before using the
device for the first time. The full performance of a
new battery is achieved only after three cycles of full
49