Tabla de contenido
16
EXPANSION CARD X-DANTE
5.5 Two X32 consoles with X-DANTE
connection to DVS for recording
64 simultaneous tracks
•
Both consoles need to have X-DANTE cards installed.
Connect one of the X-DANTE Ethernet ports on console A
with the card installed in console B.
•
Connect the second port of console B, either directly with
the DAW-PC/Mac or via a network router to which the DAW
has access. This link will carry all 64 channels to and from
both consoles.
Behringer X32
Console A
Behringer X32
Console B
Two X32 consoles with X-DANTE connection to DVS for recording 64 simultaneous tracks
•
Tip: The console's Ethernet remote control can be done over
the same network. For remote controlling console A in this
example, it is sufficient to use a short patch cable connecting
console A's Remote connector with the free port on X-DANTE.
Since both ports on X-DANTE of console B are occupied
already, you would need to patch a separate cable to the
network router.
•
Open the Dante Virtual Soundcard driver control panel and
switch it ON.
•
Run the Dante Controller application to configure the virtual
channel patch bay and route the channels between Dante
Virtual Soundcard and the consoles.
Router
(optional)
Laptop/DAW
Tabla de contenido
