Milling Cutter Holder - Nikota 05026 El Manual Del Propietario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Operation (cont'd)
Flex Shaft (cont'd)
1 Secure the clamp
base to your work
surface in a location
where the flex shaft
will not be
overextended or
bent beyond a 6"
radius.
2 Screw the hanger
rod into the base.
3 Hang the tool using the wire hanger next to the power cord.

Milling Cutter Holder

Your rotary tool kit
includes a milling
cutting holder, which
regulates the
accessory depth when
routing, milling, or
shaping. This holder
fits onto the end of the
rotary tool and features
an adjustable depth
setting. To fit the milling
cutter holder:
1 Remove the housing cap from the rotary tool.
2 Secure the attachment nut to the threaded end of the rotary tool.
3 Slide the housing over the attachment nut.
4 Insert the backstop into the slot in the housing so it rests between the
housing and attachment nut.
5 Insert the spring and setscrew.
6 Adjust the housing to the desired depth by sliding it up and down the
attachment nut. Tighten the setscrew when you reach the desired depth.
AUTHORED BY ANTHONY HERNANDEZ - (415)786-2081 - [email protected]
Owner's Manual
setsc rew
spring
backs top
19
6" radius min .
housing
attachment
nut
Tabla de contenido
loading

Productos relacionados para Nikota 05026

Tabla de contenido