Functions; Setup; Wireless Setup For Mobile Telephone; Installing Neck Loop - PhonicEar Hearlt Mobile Manual Del Usuario

Functions

R1: On/off switch, answering button, and Bluetooth
indicator
R2:
Volume button +/- (up/down)
R3: Bluetooth and volume level 1 indicator
R4: Volume level 2 indicator
R5: Battery and volume level 3 indicator
R6: Volume level 4 indicator
R7: Volume level 5 indicator
R8: Headphones jack
R9: Neck loop jack
R10: Neck loop
R11: Charging jack
Button/diode/jack
R1 • Power on (hold for up to 5 seconds)
• Power off (hold for up to 5 seconds)
• Answering and ending mobile telephone calls
• Blue light: Bluetooth active
• Blue blink: Incoming call
R2+ (up) • Volume up
R2- (down) • Volume down
• Reject mobile telephone call (hold for 2 seconds)
R3 • Blue blink: Bluetooth not connected
• Green light: Volume level 1
R4 • Green light: Volume level 2
R5 When in use
• Red blink: Low battery
• Green light: Volume level 3
When charging
• Red light: Charging
• Green light: Fully charged
R6 • Green light: Volume level 4
R7 • Green light: Volume level 5
R8 • Jack for headphones
R9 • Jack for neck loop
R10 • Neck loop
R11 • Jack for charger
R9
R7
R5
R2
R10
R3
R11
Functions
14 14

Setup

Wireless setup for mobile telephone

Establishing a wireless connection between the Bluetooth mobile telephone and the HearIt Mobile
1. Turn HearIt Mobile on by holding down the receiver button R1 for up to fi ve seconds
1. Enter the mobile telephone menu to allow the mobile telephone to search for available Bluetooth devices.
R8
2. Select the Bluetooth entry "HearIt Mobile".
3. Enter the pass code into the mobile telephone (0000). Select connect. A short beep will be heard in the
hearing aid or in the headphones.
R1
4. Once the wireless connection is established, receiver indicator R3 stops blinking blue.
R6
R4
HearIt Mobile
R3
2
3

Installing neck loop

Neck loop and T/MT function on HA
In order to use HearIt Mobile with hearing aids in T-position (telecoil), the hearing aid must be equipped with a
telecoil fi tted by the hearing care professionel.
Installing neck loop
1. Detach neck loop R10 from receiver jack R9 by pulling the loop wire.
2. Place the HearIt Mobile on the chest and place loop wire around the neck.
3. Reattach neck loop R10 to receiver jack R9.
4. Switch hearing aid to T (telecoil only) or MT (microphone and telecoil simultaneously) position.
R9
1
2
Please note:
• Once a wireless connection between HearIt Mobile
and a Bluetooth unit has been established the units will
automatically connect when they are within range of
each other.
• During telephone conversations, the receiver indicator
5
will illuminate blue indicating that the wireless connection
is active.
R9
R10
3
15 15
UK/US
R1
Please note:
• Connecting headphones
to the headphones jack R8
disconnects the signal to
the neck loop.