Programming The Alert Mode; Home Mode; Programming The Home Mode; Technical Data - Schwaiger SECURE-4-YOU Serie Manual De Instrucciones

USER MANUAL HG1000 532

8.2.1. Programming the ALERT mode

About the central unit:
Step 1
You must be in Standby Mode.
Step 4
Now press followed by the
button, in order to get into ALERT
mode.

8.3. HOME MODE

Basic setting in HOME mode
Sensor
Door/window sensor
Door/window sensor
Movement sensor

8.3.1. Programming the HOME mode

About the central unit:
Step 1
You must be in Standby Mode.
Step 4
Now press followed by the
button, in order to get into the
HOME mode.

9. TECHNICAL DATA

Remote control
Power supply
Operating frequency
Transmission Power
Radio range
House security code
Step 2
Now enter "1-2-3-4"
newly set PIN
with .
(An additional beep gives acoustic
feedback as to whether the code
that was selected is right. - Three
beeps mean that the input was not
valid.)
Step 5
Now you can use the 1-8 buttons
to add or remove the relevant
zones.
(If no zone is shown, this is deac-
tivated)
Zone
1
2
8
Step 2
Now enter "1-2-3-4"
newly set PIN
with .
(An additional beep gives acoustic
feedback as to whether the code
that was selected is right. - Three
beeps mean that the input was not
valid.)
Step 5
Now you can use the 1-8 buttons
to add or remove the relevant
zones.
ZONE is in ALERT mode
ZONE is in ARM mode
ZONE is switched off
1 x 12V batteries (A27)
868.35 MHz (+/- 0.5 MHz)
0.03 mW
Max. 60 m (open space)
Via 4-polar jumper
Step 3
or your If you enter the PIN correctly, the
and confirm this display now shows the following
image:
Step 6
Then confirm the selection using
switches into the Standby Mode
again.
Mode/Status
ALERT
ALARM
ALARM
Step 3
or your If you enter the PIN correctly, the
and confirm this display now shows the following
image:
Step 6
Then confirm the selection using
switches into the Standby Mode
again.
. The centre now automatically
. The centre now automatically
29