HiWatch DS-I1 Serie Guía Rápida página 3

Getting Started
Step 1: Install the memory card for local storage (if needed).
Step 2: Install the network camera.
1) Check the installation environment according to product datasheet.
2) Install the network camera to the mounting location suggested by HiWatch or on the product
datasheet.
Step 3: Perform wiring for network camera activation.
1) Connect the power cables. Use a power supply 110-240V
(connector with positive central).
2) Connect the network camera to a PC with a network cable.
Step 4: Set the alarm in and alarm out connection (if needed).
Relay Output
Step 5: Activate the network camera via web browser.
1) Power on the network camera.
2) Visit the network camera via its default IP address: 192.168.1.64.
Note:
For the network camera which enables the DHCP by default, you need to activate the
network camera via SADP software and search the IP address.
3) Input and confirm your password.
4) Click OK to finish activation.
Figure 1-1 Connect the Network Camera to a PC
Direct load
OUT (n)
Relay Output
+
DC
-
OUT (n)
Figure 1-2 Alarm Output Connection
, 47-63Hz, 2A / 12
GND Output
DC 30V
1A
Power Supply
OUT (n)
OUT (n)
2
EN - Quick Guide
JQC-3FG
Relay
(10A 250VAC)
~220V AC
Zero
FireWire
Line
, 5A