Troubleshooting; Product Maintenance - Envirolite EVT1012 Manual De Instrucciones

TROUBLESHOOTING

Problem
Li ght wi l l not turn on.
Fus e bl ows or ci rcui t
brea ker tri ps when l i ght i s
turned on.

PRODUCT MAINTENANCE:

1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water, never a
solvent) to wipe the surface of the fixture.
2. To clean the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker
or by removing the fuse at the fuse box. Next, use a dry or slightly dampened clean cloth (use clean
water, never a solvent) to wipe the interior surface of the fixture.
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft cloth to dust or
wipe carefully.

EnviroLite warrants this product to be free from defects in material and workmanship for five years from the
original date of purchase by the consumer. This warranty is limited to the counter replacement at the time of
purchase, with the original purchase receipt. EnviroLite
incidental or consequential damages of any kind, whether based on warranty contract or negligence, and arising in
connection with the sale, use or repair of the product claimed to be defective. Some states do not allow the
exclusion or limitation of incidental or consequential damages so the above limitation may not apply to you. This
warranty gives you specific legal rights and you may also have other rights, which vary from state to state. Misuse,
accident, improper installation or maintenance will also void the warranty.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.This device may not cause harmful interference, and
2.This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiver antenna.
• Increase the separation between the equipment and receiver.
• Install the product onto on a circuit different from that to which the receiver is connected.
• Consult with the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes made to the electronics circuit will void this equipment's compliance with Part 15 of the FCC
Rules and should not be operated.
Page 6
:
Possible Cause
1. Power i s off.
2. Fa ul ty s wi tch.
3. Fa ul ty wi re connecti on.
4. LED dri ver ha s ma l functi oned.
1. Cros s ed wi res or power wi re i s
groundi ng out.
FIVE-YEAR LIMITED WARRANTY
_____________________________
1. Ma ke s ure power s uppl y i s on.
2. Tes t or repl a ce s wi tch.
3. Check wi ri ng.
4. Repl a ce LED dri ver.
1. Check wi re connecti ons .

will not be liable for the loss or damage of any kind,
Corrective Action