Warning Information - Sunex Tools 7750C Manual Del Propietário

WARNING INFORMATION

This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility of the
device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost or not leg-
ible, contact Sunex for replacements. If the operator is not fluent in English, the product and safety instructions shall be read to and discussed
with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the operator comprehends its
contents.
THE NATURE OF HAZARDOUS SITUATIONS
The use of portable automotive lifting devices is subject to certain hazards that cannot be prevented by mechanical means, but only by the
exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel involved in the use and operation
of the equipment who are careful, competent, trained, and qualified in the safe operation of the equipment and its proper use. Examples of
hazards are dropping, tipping or slipping of loads caused primarily by improperly secured loads, overloading,
off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
• Read, study, understand and follow all instructions before operating this device.
• Inspect the jack before each use. Do not use jack if damaged, altered, modified, in poor condition, leaking hydraulic fluid, or
unstable due to loose or missing components. Make corrections before using.
• Consult the vehicle manufacturer for the transmission's center of balance.
• Secure the transmission to the jack's saddle with the anchorage restraint system provided before raising or lowering
the transmission.
• Center load on saddle. Be sure setup is stable before working on vehicle.
• Never use a power tool to activate the saddle tilt screws. Operate by hand or socket wrench.
• Support the engine with a stand before unbolting the transmission from the engine.
• Wear eye protection that meets ANSI Z87.1 and OSHA standards (users and bystanders).
• Do not use jack beyond its rated capacity. Do not shock load.
• Use only on a hard level surface capable of supporting load.
• Before moving, lower the load to the lowest possible height, ensure the load is centered and secure with a load restraint device.
• Adequately support the vehicle before starting repairs.
• Use of this product is limited to the removal, installation and transportation in the lowered position, of transmissions, transfer
cases and transaxles.
• Do not use any adapters unless approved or supplied by Sunex.
• Always lower the jack slowly and carefully.
• Do not crawl under transmission or place any part of your body under transmission at any time.
• Do not use (or modify) the product for any other purpose than that for which it was designed without consulting the
manufacturer's authorized representative.
• Failure to heed these markings may result in serious or fatal personal injury and/or property damage.
WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to
cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
Failure to read this manual completely and thoroughly and failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and neglecting the METHODS TO AVOID HAZARDOUS SITUATIONS could cause
accidents resulting in serious or fatal personal injury and/or property damage.
7750C
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
2
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
rev. 1/22/20