Sunex Tools 8057 Manual De Instrucciones página 2

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
Hardware Specifications:
Handle
Hardware
4 pcs
Caster
Hardware
16 pcs
PROBLEM: Drawers appear not to fit, do not slide in accurately and bump the cart sides.
SOLUTION: The roller bearing slides must be fully engaged into the mounting slots on all drawers (see fig. 1 below). They
potentially could fall out of position during shipment. Check the side of the cart to determine which slide is out of position.
Remove the drawer that is out of position. The drawer is removed by the two clips on the actual roller bearing slide.
Simply push the roller bearing slide back down into position.
Insert the drawer back onto the roller bearing slides.
PROBLEM: Back lock / unlock switch does not engage the drawer.
SOLUTION: The inside lock / unlock slide potentially could fall out of its groove during shipment. Unscrew the four screws
that are holding the lock / unlock slide in place.
Once the screws are removed, simply place the latch back onto the slide and tighten the four screws back down.
MOUNTING
SLOTS
8057/8057BK/8057G/8057MB/8057O/8057P/8057S
MODEL 8057 / 8057BK / 8057G / 8057MB /
4 pcs
4 pcs
16 pcs
16 pcs
FIG. 1
8057O / 8057P / 8057S
PREMIUM FULL DRAWER
2
SERVICE CART
Rev. 06/11/18
Tabla de contenido
loading

Este manual también es adecuado para:

8057bk8057g8057mb805708057p8057s

Tabla de contenido