Installation; Programming - Metra 108-FD4CH Instrucciones De Instalación

INSTALLATION

It is highly advisable to read the following steps beforehand, to ensure a clear understanding of
what is to be expected. The following steps must be done in the order that they are numbered.
With the vehicle completely off:
1. Connect the 16-pin harness with stripped leads into port "B" in the touchscreen display.
2. Connect the main harness to the wiring harnesses in the vehicle. These harnesses are the
ones removed in step 3 of dash disassembly. Then insert the main harness into port "A"
in the touchscreen display. But do not install this harness until exactly before step 1 from
the Programming section. This is a timed process.
3. If installing a backup camera, and the image is desired to to be displayed onto the
touchscreen display, connect the 4-pin harness with yellow RCA jacks into port "C" in
the touchscreen display.
4. Disregard ports "D" and "E", they will not be used in this application.
5. Port "F" is an update port for future firmware upgrades.
6. Locate the factory antenna connector in the dash and complete all necessary connections
to the radio. Use the antenna adapter provided to adapt the factory antenna connector to
the aftermarket radio.
A
F
Note: DO NOT CONNECT!
B
C
D
E

PROGRAMMING

1. Refer to step 2 from the Installation section.
2. Start the vehicle.
3. Program the kit:
a. Once the touchscreen display loads up, select the vehicle type.
b. Wait until the radio comes on, and the touchscreen display shows SWC Configured*.
This process may take up to 3 minutes.
Note: f the touchscreen display does not load up, or the radio doesn't come on within
3 minutes, and/or the touchscreen display does not show SWC Configured*, check all
connections, then reset the interface and try again. Refer to the Troubleshooting section.
* For models with steering wheel controls.
4. Cycle the key off. If the driver's door is closed, open and close the door.
Cycle the key back on.
5. Test all functions of the installation for proper operation, before reassembling the dash.
REV. 10/29/2020 INST108-FD4CH
7