Maintenance; Generator Maintenance; Maintenance Schedule - EarthQuake IG800W Manual Del Operador

MAINTENANCE

GENERATOR MAINTENANCE

Please read the maintenance schedule and observe these recommendations to extend the life of your generator.
Good maintenance is essential for safe, economical, and trouble-free operation. It will also help reduce air pollution. To help you
properly care for your generator, the following pages include a maintenance schedule, routine inspection procedures, and simple
maintenance procedures using basic hand tools. Other service tasks that are more difficult, or require special tools, are best handled
by professionals and are normally performed by a technician or other qualified mechanic.
Maintenance, replacement or repair of the emissions control devices and systems may be performed by any non-road engine
repair establishment or individuals. However, items must be serviced by an authorized dealer to obtain "no charge" emissions
control service.
The maintenance schedule applies to normal operating conditions. If you operate your engine under unusual conditions, such as sustained
high-load or high-temperature operation, or use in unusually wet or dusty conditions, consult your servicing dealer for recommendations
applicable to your individual needs and use.

MAINTENANCE SCHEDULE

Maintenance Item
Spark Plug -
Type: CMR6A (TORCH)
Gap: 0.6 - 0.7 mm
Engine Oil
Air Filter
Fuel Strainer
Choke
Valve Clearance -
Intake: 0.15mm (0.006")
Exhaust: 0.20mm (0.008")
Fuel / Oil Lines
Exhaust System
Starting System
Screws / Fasteners
Generator
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
Remarks
Check condition, adjust gap and
clean. Replace if necessary.
Check oil level.
Replace.
Clean. Replace if necessary.
Clean fuel strainer.
Replace if necessary.
Check choke operation.
Check and adjust when
engine is cold.
Check hoses for crack or damage.
Replace if necessary.
Check for leakage.
Retighten if necessary.
Check muffler screen.
Clean/replace if necessary
Check recoil starter operation.
Check that all hardware is secure.
Correct if necessary.
Check the output light comes on.
Initial
Pre-operation
month
check (daily)
or 20 hrs
X
X
X
X
X
X
X
Operator's Manual
800 Watt Inverter Generator
Every 3 Every 6
months months
or 50 hrs or 100 hrs or 300 hrs
X
X
X
X
X
Every 12
months
X
X
15