Tabla de contenido
Idiomas disponibles
Idiomas disponibles
General Instructions
Installation: Riser &
HoseAssembly
See separate instructions for installing
no.1 into deck.
1. Shut off water supply and drain
lines.
2. Apply teflon tape or pipe joint
compound on both ends of no.3.
3. Screw no.3 firmly into no.1 by hand.
4. Slide no.2 down no.3
(about halfway) and
tighten
temporarily.
5. Screw no.6
firmly onto no.3,
and firmly tighten
no.6 with a wrench.
washer
wall bracket
(optional)
6. Remove no.8 and no.9 from no.6.
Apply teflon tape or pipe joint
compound to threaded end of no.8.
7. Screw threaded end of no.9 into
ball end of no.10.
8. Apply a coat of grease to no.7 (if
replacing). Install and tighten no.8
and no.9 into no.6.
Note: Also use step 6 and 8 of this
procedure for replacement of worn
or damaged no.7.
9. Attach end of no.11 to no.10.
(Make sure hose washer is in place).
No.12 should rest in a comfortable
position on no.2 when completely
assembled.
10. Turn on water and check for
leaks.
Optional Wall Bracket
Note: T&S Brass highly recom-
mends installing a B-0109-01 Wall
Bracket to no.3 with these Pre-
Rinse Units for a more secure
installation. Fit as high as possible
on no.3. Cut off any excess nipple
(unthreaded end) as needed, and
mount to wall.
Tabla de contenido
