Safety Cautions - Remington Straightini S2880 Manual De Usuario

Ocultar thumbs Ver también para Straightini S2880:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
ENGLISH
WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION OF A
RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL OPERATING
CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN ELECTRICIAN FOR
ADVICE.
WARNING – THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM,
IT SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS, BASINS OR OTHER
VESSELS CONTAINING WATER OR OTHER LIQUIDS.
THE STYLER SHOULD BE UNPLUGGED FROM MAINS SUPPLY WHEN NOT IN
USE.
Do not leave the styler unattended when switched on.
Allow the styler to cool down before storage.
Do not immerse in water or other liquids.
Do not place styler on soft material e.g. carpet, bedding, towels, rugs etc.
Always ensure the voltage to be used corresponds to the voltage stated on the unit.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge can
give cause to hazards. Persons responsible for their safety should give explicit instructions
or supervise the use of the appliance.
Do not use any attachments with this styler, other than those supplied by Remington
Avoid allowing any part of the hot plates to contact the face, neck or scalp.
Do not wrap the cord around the unit. Check cord regularly for any sign of damage.
This product is not intended for commercial or salon use.
Damaged cords can be dangerous. If the supply cord of this unit becomes damaged,
discontinue use immediately and contact the Remington
replacement in order to avoid a hazard.
Special tools are required for any examination, adjustment or repair. Unqualified repair
work could lead to hazardous conditions for the user.
We do not accept responsibility for damage to the product, persons or other items(s),
caused by misuse, abuse or non-compliance with these instructions.
This product is fitted with a BS1363 plug fused at 13A. If the plug is unsuitable, it should be
disconnected and an appropriate plug fitted as detailed below. If it is necessary to replace
the plug fuse, use only fuses that are approved to BS1362, rated at 13A. If in doubt consult a
qualified electrician.
The wires in the mains lead are coloured in accordance with following code:
2
100205_REM_IFU_S2880_21L.indd GB_2
100205_REM_IFU_S2880_21L.indd GB_2

SAFETY CAUTIONS

This product is not suitable for use in bath or shower.
WIRING INSTRUCTIONS UK Plugs Only
®
help desk for repair or
®
.
30.03.10 20:21
30.03.10 20:21
Tabla de contenido
loading

Tabla de contenido