riptunes CDB300 Guia Del Usuario página 11

Programming the CD Player
The programming of the CD player should be done during STOP mode.
1. Press the (STOP) button to stop the currently loaded CD.
2. Press the (MEM/PROG) button. The LCD display will show 'P 01'.
3. Press the or
4. Press the PROGRAM button again to store this track in memory. The LCD will show 'P02'.
5. Repeat steps 2 and 3 to store more tracks in memory. You can store up to 20 tracks in the memory.
6. Press the (PLAY/PAUSE) button to confirm the programmed selections. The list will begin playing
from the first programmed track. The player will stop automatically after all tracks have played.
7. To cancel the programming list, press the
Playing An MP3 Disc
Press the FUNCTION button to turn the unit on. Press again until ' CD ' is indicated on the display screen
(if no CD or MP3 disc is inserted). Otherwise, ' NO ' will appear. As MP3 Discs have a large storage capacity,
disc access time is a little longer.
1. Open the CD compartment. Hold the disc with the label side facing up and place it onto the spindle
until it clicks into place. Close the CD compartment door.
2. Be sure that Function is set to the "CD/ MP3" position. The disc will rotate for a few seconds. The first
track of the disc will automatically play. Adjust the volume as desired.
3. Press the PLAY/PAUSE button to stop playing temporarily. The Track number will begin to
Flash on the LCD screen. Resume normal play by pressing the PLAY/PAUSE button again.
4. To stop playback, press the STOP button. The total number of tracks will be shown on the display.
buttons to select the desired track.
(STOP) button.
- 10 -