Air Supply - Matco Tools MT2883 Manual De Instrucciones

FEATURES
• High performance efficient 1/2 HP motor for extra torque and extended durability
• Ideal for polishing and grinding jobs with all size pads!!
• Heavy duty industrial cut gear design for extra long life and quiet performance
• 90 degree angle head for work in limited access areas
• Positive stop regulator for more versatile performance on all types of jobs
• Super comfortable safety throttle lever to prevent accidental start ups
• Adjustable rear exhaust to direct air away from the user
• 3 piece industrial grade collet for high performance
• Composite nylon housing cover for extra job comfort and durability

AIR SUPPLY

Tools of this class operate on a wide range of air pressures. It is
recommended that air pressure of these tools measures 90 PSI
at the tool while running free. Higher pressure and unclean air
will shorten tool life because of faster wear and may create a
hazardous condition.
Water in the air line will cause damage to the tool. Drain the air
tank daily. Clean the air inlet filter screen on at least a weekly
schedule. The recommended hook-up procedure can be viewed
in Figure 1.
The air inlet (Figure 2), used for connecting air supply, has standard 1/4"
NPT American Thread.
Line pressure should be increased to compensate for unusually
long air hoses (over 25 feet). Minimum hose diameter should be 3/8"
I.D. and fittings should have the same inside dimensions.
WARRANTY
Matco warrants its air tools for a period of 1 year to the consumer. We
will repair any MT Series air tool covered under this warranty which
proves to be defective in material or workmanship during the warranty
period. In order to have your tool repaired, return the tool to either of the
Matco Authorized Warranty Centers listed below, freight prepaid. Please
include a copy of your proof of purchase and a brief description of the
problem. The tool will be inspected and if any part or parts are found to
be defective in material or workmanship, the tool will be repaired free
of charge and returned to you freight prepaid.
This warranty gives you specific rights. You may also have other rights
which vary from state to state.
The foregoing obligation is Matco's sole liability under this or any
implied warranty and under no circumstances shall Matco be liable for
any incidental or consequential damages.
MT2883
MT2883_OpMan_022406.indd 3
MT2883 .50 HP Right Angle Die Grinder
FIG. 1 FIG. 1
TROUBLESHOOTING
Other factors outside the tool may cause loss of power or erratic
action. Reduced compressor output, excessive drain on the air line,
moisture or restrictions in air pipes or the use of hose connections
of improper size or poor conditions may reduce air supply. If
outside conditions are in order, and the tool still performs erratically,
disconnect tool from hose and take tool to your nearest Matco
authorized service center.
LUBRICATION & MAINTENANCE
Lubricate the tool daily with a good grade of air tool oil. If no
air line oiler is used, run a teaspoon of oil through the tool. The oil
can be squirted into the tool air inlet Figure 2, or into the hose at the
nearest connection to the air supply, then run the tool. A rust inhibitive
oil is acceptable for air tools.
AIR INLET
Note: Some states do not allow the exclusion or limitation of
incidental or consequential damages so the above limitation or
exclusion may not apply to you.
Matco Air Command
Tool Repair SV
1330 Commerce Dr.
Stow, OH 44224
(800) 433-7098
Discount Tool Repair
3433 Losee Rd. #1
North Las Vegas, NV 89030
(702) 657-6570
3
FIG. 2 FIG. 2
Rev. 02/24/06
2/24/06 2:34:17 PM