Insert Batteries - Revell Control BLACK SHADOW Manual De Instrucciones

Helicopter
Stabilizer
Tail rotor
Landinggear
Controller
Throttle stick
Band selector (A, B, C)
"POWER ON" LED
1. Remove the screw
Note: Before recharging and after every flight, always wait 10 to 15 minutes for the battery to cool down in order to avoid damage. Never leave the helicopter unattended when recharging.
1. Turn off the helicopter and the controller.
2. Pull out the charging wire from the bottom
of the controller (pic. 1).
3. Carefully plug the charging wire into the
helicopter's charging port (pic. 2). The charging
wire should fit easily into the charging port –
DO NOT FORCE. Inserting the charging wire
incorrectly may damage the helicopter and
cause injury.
4. Turn the power switch on the controller to
"ON" (Charge) (pic. 3).
5. The red Power ON LED flashes and the green
charging status LED lights up now (Fig. 4).
6. The charging procedure is complete as soon as
the green charging status LED has gone out.
7. After charging, turn the power switch to
"OFF" and remove the charging wire from
the helicopter.
6
Helicopter and Controller
to release the bat-
tery cover and slide
downwards.
Charging the Helicopter
The helicopter can be flown for about 8 minutes
after approximately 30 minutes of charging
Counter-rotating
rotor blades
LED lights
Infrared signal emitter
Direction stick
(forwards, backwards,
left and right)
Power ON/OFF and
charge switch
Right and left trim dial
Charge status LED

Insert Batteries

2. Insert six 1.5 V AA batter-
ies following the polarity
shown inside the battery
cover.
Pic. 1
Charging port
ON/OFF switch
Starting position
Note: Before
turning on the con-
troller, the throttle
stick must be in the
down position.
Battery cover
3. Slide the battery
cover upwards
and screw in
place.
Pic. 3
Pic. 4
Pic. 2