Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Battery replacement/disposal
BATTERY REPLACEMENT
The battery should last the service life of the unit. Service life is dependent on a number of factors including but not limited to
the number of recharge cycles, and proper care and maintenance of the battery by the end user. Contact manufacturer for any
information you may need.
SAFE BATTERY DISPOSAL
Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be disposed of properly.
Recycling is required. Failure to comply with local, state and federal regulations can result in fines, or
imprisonment.
Please recycle.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can
result in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
TROUBLESHOOTING
Unit will not charge
• Make sure all of the unit's functions are turned off.
• Make sure a suitable gage extension cord is properly connected to both the unit and a functioning AC outlet.
Unit fails to jump-start
• Make sure unit's Jump Starter Power Switch is in the on position.
• Make sure a proper polarity cable connection has been established.
• Make sure the unit is not being operated in the Compressor mode.
• Check that the unit has a full charge. Recharge the unit if necessary.
Portable compressor will not inflate
• Make sure the Compressor Power Button has been pressed to turn the compressor on.
• Make sure the unit is not being operated in the Jump Starter mode.
• Make sure the SureFit
nozzle is securely screwed on to the valve stem when attempting to inflate tires; or that the nozzle
®
adapter is securely screwed into the SureFit
inflatables.
• Check that the unit has a full charge. Recharge the unit if necessary.
USB power port will not power appliance
• Make sure the USB Power Button is in the on position.
• Make sure all the USB Power/Fault Indicators light solid blue. If a fault condition exists in either of the first two USB Ports, the
upper set of USB Power/Fault Indicators will flash blue. If a fault condition exists in either of the bottom two USB Ports, the
lower set of USB Power/Fault Indicator will flash blue. Refer to the Important Notes in the "USB Ports" section to remedy any
faults.
• Make sure that the total draw of all USB devices plugged into the top two USB Ports does not exceed 3.1A and/or the total
draw of all USB devices plugged into the bottom two USB Ports does not exceed 3.1A.
• Some USB-powered household electronics will not operate with this USB charging/power port. Check the manual of the
corresponding electronic device to confirm that it can be used with this type of USB charging/power port.
• Check that the unit has a full charge. Recharge the unit if necessary.
LED area light does not come on
• Make sure the area light power button is in the on position
• Check that the unit has a full charge. Recharge the unit if necessary.
ACCESSORIES
Recommended accessories for use with your tool may be available from the manufacturer. If you need assistance regarding
accessories, please contact the manufacturer at (877) 571-2391.
WARNING: The use of any accessory not recommended for use with this appliance could be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts, contact the manufacturer at (877) 571-2391.
nozzle and is inserted properly into the item to be inflated on all other
®
15
Tabla de contenido
