Hardware Installation - LevelOne FBR-1415TX Guía De Instalación Rápida

English
Congratulations on your purchase of this outstanding LevelOne FBR-1415TX Broadband Router.
This is a step-by-step instruction of how to start using the router and get connected to the Internet.
Any further problem, please refer to the User`s manual.
Please turn off the power, remove the power cord from the outlet, and keep your hands dry when you try to install the
hardware of this product.
1.1 Procedure for Hardware Installation (Please refer to Fig 1)
1. Setup LAN connection: connect an Ethernet cable from your computer's Ethernet port to one of the
LAN ports of this product.
2. Setup WAN connection: prepare an Ethernet cable for connecting this product to your cable/xDSL
modem or Ethernet backbone.
3. Power on:
Connecting the power cord to power inlet and turning the power switch on, this product will
automatically enter the self-test phase. When it is in the self-test phase, the "STATUS" LED indicator
will be lighted ON for about 5 seconds, and then STATUS LED will be flashed 3 times to indicate
that the self-test operation has finished. Finally, the "STATUS" LED will be continuously flashed
once per second to indicate that this product is in normal operation.
To reset system settings to factory defaults, please follow the steps:
RESET
1. Power off the device,
2. Press the reset button and hold,
3. Power on the device,
4. Keep the button pressed about 5 seconds,
5. Release the button,
6. Watch the Status LED , it will flash 8 times and then Status flash
once per second.

1 Hardware Installation

5