Recommendations On Use; Maintenance; In Case Of Problem - Atlantic 2012 Manual De Utilización E Instalación

- When ventilating the room, stop the heating by setting the switch
- If you leave for several hours, lower the temperature.
Leaving for: Less than 24 hours
More than 24 hours or during summer :set the temperature knob to
- To maintain the performance of the device, about twice per year, clear the dust.
Do not use abrasive products.
Problem
The device does not heat
The heating device
heats constantly
The device's surface is very
hot
The last elements top and
bottom are cooler than the
rest of the device
The device does not follow
the programming instruc-
tions
R
ECOMMENDATIONS OF USE
M
AINTENANCE
I
N CASE OF PROBLEM
- Check that the premise circuit breakers are triggered or that the
shedder (if you have one) has not interrupted the device's power
suply.
- Check the air temperature in the room.
- Switch the heating off, then back on (
• If the indicator blinks 3 times: the measurement probe is dama-
ged. Call your electrician to ensure its replacement.
• If the indicator blinks 5 times: power surge in device supply.
Power off the device (fuse, circuit breaker...), and call your electri-
cian.
- Check that the device is not located in a draft or that the tempera-
ture setting has not been altered.
It is normal for the device to be hot when it is operating. The maxi-
mum surface temperature is restricted in accordance with the NF
Electricité Performance standard. However, if you think that your
device is always too hot, check that the output is suitable for the area
of your room (we recommend 50W / m
placed in a draught, which would disrupt its setting.
- At the top, the upper elements are not completely filled to allow
for expansion of the thermodynamic fluid. They heat up only by
conduction.
- At the bottom, the elements convey the fluid return, which has
transmitted its heat.
- Ensure that the programming unit is being used correctly (refer to
its operating manual).
:do not touch the controls.
Check
14
to the Arrêt position.
switch):
) and that the device is not
3
.