Owner's Guide
Installing the thermostat
1)
Turn the heating system off at the main electrical panel.
2)
Loosen the bottom screw and remove the thermostat faceplate
from its wallplate. (The screw cannot be completely removed.)
3)
Wire the thermostat. See connection diagram on page 7.
4)
If the thermostat will be used in F or AF mode (see page 9),
connect the floor sensor (see page 7).
5)
Install the wallplate on the wall using the provided screws and
wall anchors.
6)
Set the configuration switches (see page 9).
7)
Install the faceplate back on the wallplate and tighten the
screw. If there is a sticker on the screen, peel it off.
8)
Apply power to the heating system at the main electrical panel.
6
Faceplate
Wallplate