Emerson inSinkerator TranScape View Instalacion, Cuidado & Uso página 7

2
INSTALLING THE FAUCET - HC3/ GN3
A
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
B
Rubber Washer
1
1 ⁄ " Hole
4
BOTH 1 5 ⁄ " small steel and rubber washers
8
MUST BE INSTALLED to ensure
proper operation and seal.
C
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
D
From faucet
An extension is available by special order
(EXT-10) for counters more than 3/4" thick.
Call 1-800-558-5700 to order.
1 5 ⁄ " Small
8
Steel Washer
1 5 ⁄ " Small
8
Hole larger than 1
Fiber
Washer
3/8" white tube
HC3/GN3
I I
Unpack dispenser components.
I I
On a firm, flat surface, carefully
straighten the copper tubing using
hands only.
I I
Remove the wing nut from
the valve body.
HC3/GN3
1 5 ⁄ " Small
8
Steel Washer
I I
For a 1
washers on the faucet base in this
1
5 ⁄ " Rubber
8
order (see diagram):
Washer
5 ⁄
1) 1
2 1 ⁄ " Large
8
4
Steel Washer
5 ⁄
2) 1
8
I I
For a hole larger than 1
1 ⁄ " washers on the facuet base in this
4
order (see diagram):
⁄
1) 1 5
8
5 ⁄
2) 1
8
1 ⁄
3) 2
4
HC3/GN3
I I
Feed tubes down through the hole
in the sink or counter until the base
is at rest.
I I
Make sure faucet head is at the
desired angle.
Wing Nut
I I
Slide 2
base under sink. Tighten assembly
using black plastic wing nut.
HC3 only
I I
Attach the quick connector to the
ends of the copper tubes running
from the dispenser.
I I
Install a white 3/8" tube into
quick connector.
I I
1 ⁄ "
sink hole, place the
4
" small steel washer
" small rubber washer.
1 ⁄
4
" small steel washer
" rubber washer
" large steel washer
⁄ " fiber washer over faucet
1
4
", place the
7