Ch3 Channel Learning; Ch4 Channel Learning; Deleting Remote Controls; Deleting All The Learned Remote Controls - Vimar Elvox ECRU Manual Para El Conexionado Y El Uso

7 . Ch3 ChANNEL LEARNING (only if module ECRU.CA is present in slot JPEX3)
The DL3 LED blinks: waiting to receive remote controls to be saved and associated with the output Ch3.
DL1...DL4 green flash: receiving and saving remote control OK.
DL1...DL4 orange flash: receiving an invalid remote control.
DL1...DL4 red flash: receiving a remote control but memory is full (500 codes)
- Pressing button P1 for at least 2 sec:
The DL3 LED goes out, the DL4 LED flashes, and the receiver goes into CH4 channel learning mode (see point 8).
- Pressing button P1 or button P2:
the receiver quits the Ch3 channel learning mode and returns to its normal operating state (see point 4).
- After 15 seconds of inactivity:
the receiver automatically quits the Ch3 channel learning mode and returns to its normal operating state (see point 4).
8 . Ch4 ChANNEL LEARNING (only if module ECRU.CA is present in slot JPEX4)
The DL4 LED blinks: waiting to receive remote controls to be saved and associated with the output Ch4.
DL1...DL4 green flash: receiving and saving remote control OK.
DL1...DL4 orange flash: receiving an invalid remote control.
DL1...DL4 red flash: receiving a remote control but memory is full (500 codes)
- Pressing button P1 for at least 2 sec:
The DL4 LED goes out, the DL1 LED flashes, and the receiver goes into CH1 channel learning mode (see point 5).
- Pressing button P1 or button P2:
the receiver quits the Ch4 channel learning mode and returns to its normal operating state (see point 4).
- After 15 seconds of inactivity:
the receiver automatically quits the Ch4 channel learning mode and returns to its normal operating state (see point 4).

9 . DELETING REMOTE CONTROLS

The DL1...DL4 LEDs blink red: waiting to receive remote controls to be deleted. DL1...DL4 green flash:
receiving and deleting the remote control.
The deleted remote control will no longer be able to activate the receiver outputs.
- After 30 seconds of inactivity:
the receiver automatically quits the deletion mode and returns to its normal operating state (see point 4).
- Pressing button P1 or button P2:
the receiver quits the deletion mode and returns to its normal operating state (see point 4).
10 . TOTAL DELETION OF LEARNED REMOTE CONTROLS
Simultaneously pressing buttons P1 and P2:
the four LEDS DL1...DL4 flash red at high frequency. Press and hold down the buttons for 6 seconds, the LEDs will come
on green for 1 sec., and the memory of all the remote controls learned by the receiver will be completely deleted. No remote
control will then be able to activate the receiver outputs.
Subsequent learning of a Rolling Code or Fixed Code type of remote control will determine the type managed from that point
on by the receiver.
10 EN