Install The Housing; Install The Camera In The Housing; Install The Wall Bracket - Axis Q1921 Guia De Instalacion

Axis Thermal Camera Accessories and Spare Parts Installation Guide

Install the housing

The instructions below describe how to install an indoor thermal network camera in a housing, see
www.axis.com for information on outdoor housings and other accessories.

Install the camera in the housing

1. Remove the upper holder, see illustration on page 7.
2. Secure the camera to the upper holder with the screw and washer.
3. Fit the upper holder on the lower holder and adjust the distance between holders according to
the table in Adjust the holder distance, on page 9.
4. Tighten the screws to 2 Nm. Be careful not to overtighten the screws.
5. Connect the window heater cable to the window heater connector on the camera, see
illustrations on page 6 and page 7.
6. Optionally insert an SD card (not included) into the SDHC (Secure Digital High
Capacity) card slot. A standard or high capacity SD card is required to store images locally in
the camera.

Install the wall bracket

1. Use the supplied drill template to prepare a wall for installation of the wall bracket.
2. Route the network cable through the wall bracket and the bracket adapter. Leave
approximately 30 cm (11.8") of cable for connecting the camera.
3. Install the wall bracket on a wall and make sure that the screws and plugs are appropriate for
the material (e.g. wood, metal, sheet rock, stone).
Notes:
• Check that the material is strong enough to support the weight of the camera.
• For more technical specifications, please see the camera's User Manual, available from www.axis.com
Route the network cable through the cable hole
1. Loosen the cable cover screws; detach the cable cover from the bottom cover.
Cable gland
2. Remove the cap, the plug and the gasket from the cable gland that is to be used.
3. Route the network cable through the cap.
Gasket
Plug (discard)
Cap
Page 11