Operating Your New Appliance; Before First Use - Sage BKE700 Guía Rápida

OPERATING YOUR NEW APPLIANCE

BEFORE FIRST USE

Remove any promotional material attached to
your kettle. It is recommended that before first
use, the kettle is filled to the maximum level with
cold tap water, boiled and water discarded.
OPERATION OF YOUR KETTLE
To fill the kettle, remove it from the power base
and open lid by pressing the lid release button.
Fill with the desired amount of water.
NOTE
Always fill the kettle between the minimum
(500ml) and maximum (1700ml) marks on
the water window.
Ensure the lid is locked firmly into place.
Position the kettle securely onto the power base.
Insert the power plug into a 230–240V power
outlet and switch on.
Press the 'On / Off' switch to the 'On' position for
water to boil.
NOTE
This kettle must only be used with the
power base supplied. Use caution when
pouring water from your kettle, as boiling
water will scald. Do not pour the water
too quickly.
The kettle will automatically switch 'off' once the
water has boiled.
If further heating of the kettle is not required,
switch 'Off' at the power outlet, unplug the
power cord and empty the water from the kettle.
Replace the kettle onto the power base and
close the lid.
SAFETY BOIL DRY PROTECTION
The kettle is fitted with a safety device, which
protects against overheating should the
appliance be operated with insufficient water.
If this occurs, the kettle will stop heating.
Switch 'Off' at the power outlet and allow
kettle to cool before refilling. Remove the
kettle from the power base and add water.
Return the kettle to the power base. The
safety device will then automatically reset.
For additional safety, your kettle is fitted with
an additional thermal cut out. In the event of
overheating, the kettle will automatically shut
down to prevent further damage. Should
this occur, take your kettle to an authorised
Sage Service Centre.
®
EN
7