Tabla de contenido
Idiomas disponibles
Idiomas disponibles
BEFOR USING YOUR
ALL REFRIGERATOR
• Remove the exterior and interior packing.
• Before connecting the refrigerator to the power source,
let it stand upright for approximately 2 hours. This will
reduce the possibility of a malfunction in the cooling
system from handling during transportation.
• Clean the interior surface with lukewarm water using a
soft cloth.
• When disposing your appliance, please choose an
authorized disposal site.
INSTALLATION OF YOUR
ALL REFRIGERATOR
• Place your refrigerator on a floor that is strong enough
to support it when it is fully loaded. To level your
refrigerator, adjust the front leveling leg at the bottom of
the refrigerator.
• Locate the refrigerator away from direct sunlight and
sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the exterior of the cabinet and heat
sources may increase electrical consumption. Extreme
cold ambient temperatures may also cause the unit not
to perform properly.
• Avoid locating the unit in moist areas.
• Plug the refrigerator into an exclusive, properly
installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong
from the power cord. Any questions concerning power
and/or grounding should be directed toward a certified
electrician or an authorized service center.
ATTENTION
• In order for the cabinet to remain efficient do not over
load it;
• Do not open the door unless necessary;
• Do not cover shelves with aluminum foil or any other
shelf material which may prevent air circulation;
• Should the refrigerator be stored without use for long
periods it is suggested, after a careful cleaning, to leave
the door ajar to allow air to circulate inside the cabinet in
order to avoid possible formations of condensation,
mold or odors.
INSTALLATION INSTRUCTIONS
INSTALLATION SPECIFICATIONS
FOR BUILT IN APPLICATION
TOOLS YOU WILL NEED
While performing installations described in
this section, gloves, safety glasses and
goggles should be worn.
• It is recommended that you do not install the unit directly beside
a wall. This is to allow the door to have a greater then 90° opening
swing. A limited door swing may lead todamaging the door gasket.
• The rough cabinet opening must be on a level floor area and at
least 26" deep by 24" wide. The opening should also have a
height
of at least 34 3/4".
• The electrical outlet may be positioned from within either side of
the adjacent cabinetry, or the rear of the shaded area
(as shown in Fig A).
• If the electrical outlet is located inside the adjacent cabinetry, cut a
1-1/2" diameter hole to admit the power cord. If the cabinet wall is
metal, the hole edge must be covered with a bushing or grommet.
NOTE:
• This refrigerator is in accordance with Energy Star, but in order to
get the best energy efficiency, the built-in size should be:
Width- 25 9/16" x Height- 35 7/16" x Depth- 26"
• If you did not leave enough installation size for the refrigerator
in your kitchen, please refer to the installation drawing below.
Attention: The below installation method will not affect the
performance of the unit but will affect the accordance with
Energy Star.
Fig.A
FigA
34 3/4 " from
3
34
/4 " from
underside of
underside
countertop to
of
floor.
countertop
tofloor
2
1
1 1/2" diam. hole
1
/2 "d iam.hol e
* If electrical outlet
* I f electrical
out -
is in adjacent
let isin
cabinetry.
cabinetry .
26"
Electrical Access
Cabinets
Cabinet s
square
square
and plumb
and
plumb
24"
Tabla de contenido
