Taurus ALPATEC MG17 Manual Del Usuario página 10

INSTALLATION
- Make sure that all the product packaging has
been removed. To prevent possible risk of
accidents, do not leave elements such as plastic
bags, polystyrene or electrical cords within the
reach of children.
- During transportation, the appliance must
never be tilted more than 45°. Do not turn the
appliance upside down as this may damage the
compressor
- Do not remove the appliance's support feet
- Place the appliance on a flat, stable surface
away from any heat sources.
- The power point must be easily accessible so
that the appliance can be quickly disconnected
in case of emergency.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all the product's packaging has
been removed.
- Before using the product for the first time, clean
the parts that will come into contact with food in
the manner described in the cleaning section.
- It is advisable to wait at least 2 hours after
having installed the appliance before using it for
the first time, leaving the front cover open.
- Prepare the appliance according to the function
you wish to use.
FILLING WITH WATER:
FILLING MANUALLY (FIG.1)
FILLING WITH RUNNING WATER (FIG.2)
- The tank must be filled with water before turning
the appliance on.
- Remove the container from its base.
- Fill the tank with cold water.
- Fill the container taking care to observe the
MAX and MIN level.
- Put the container back into position.
USE:
- Ensure that the electronic connector is properly
attached to the appliance.
- Fill with appliance with water, respecting the
maximum level. Do not put anything other than
drinking water in the water tank
- Connect the appliance to the mains.
- Turn the appliance on using the ON button (A).
- Production time varies between 7-12 minutes
(depending on water temperature and ambient
temperature) Caution: The ice cubes produced
may be small and misshaped during the first 3
cycles.
- Note: the ice cubes may not be completely
transparent, due to air that enters during
production, however, this is no way alters the
quality of the ice cubes.
- The "Tank empty" icon (E) will appear when the
water is empty.
- Switch off the appliance
- Fill the tank, respecting the indicated maximum
level.
- Wait 3 minutes before switching the appliance
back on.
- Icon (H) will appear when the ice cube tank is
full
- Press (6) to dispense ice Make sure to have a
container below it.
- Press (D) to dispense chilled water Make sure
to have a container below it.
- Press (C) to select large ice cubes
- Press (B) to select small ice cubes
- To empty the water tank, open the drain plug
(16) which is inside the tank, making sure to
have a container positioned below the applian-
ce.
- When the tank is empty refit the plug (16) back
in the the tank.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- After use press the OFF button (A) to switch off
the appliance.
- Turn the appliance off, using the on/off switch.
- Unplug the appliance to the mains.
- Empty the water from inside the tank.
- If the appliance is not going to be used for a
prolonged period, empty and dry the tank before
storing it.
- Clean the appliance
CLEANING
- Disconnect the appliance from the mains and let
it cool before undertaking any cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
to clean the appliance.
- Do not submerge the appliance in water or any
other liquid, or place it under a running tap.
- Never submerge the connector in water or any
other liquid or place it under running water.