Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1. Tape Template to desired position and mark holes as indicated:
Cabinet can be installed on left or right side of wall. Clearance: If cabinet is mounted
under soap pump, allow 5" (130mm) under top surface of counter for shank extension
connection.
Thick Countertop
Installer Note:
If counter top is more than 1-3/4'' (45mm) thick and a 6'' (150mm)
shank (Part No. 822-408) is used, 8" (205mm) clearance under top
surface of counter is required.
2. Drill 5/8" holes as marked by template.
If drilling into stud, drill 3/16" hole. Provide adequate backing where necessary.
3. Important: Keep bolt loose until cabinet has been placed on brackets.
4. Attach Brackets to Wall with Toggle Bolts (supplied). Use a level to ensure brackets
are leveled horizontally.
* For Tile Only: Bottom 2 toggle bolts can be replaced with #10 screws and blue
anchors (not provided).
5. Route tubing through hole in cabinet side panel or back wall.
Form No. 830-569 r11/13/12
Cabinet Installation
S/F
© 2018 Bobrick Washroom Equipment, Inc.
5 th
Mounting Hole
5 th
Mounting Hole
Finish Face of Wall
5 th
Mounting Hole
Level
*
Printed in U.S.A.
*
Tubing
Page 3
Tabla de contenido
