JB Systems LED Victory Scan Mk2 Manual De Instrucciones página 12

ENGLISH
DMX-Chart for 8CH working mode
This is the i-Solution compatible DMX-mode. We recommend using the standard 7channel mode if you don't
use an i-Solution controller. The DMX-values are identical to those of the 7CH mode, only the channel lineup
is different:
- CH1: PAN
- CH2: TILT / BARREL ROTATION
- CH3: STROBE
- CH4: GOBO
- CH5: COLOR
- CH6: NOT USED
- CH7: DIMMER
- CH8: SPECIAL FUNCTIONS
OPERATE THE UNIT BY CA8 OR RF8SET
When used in standalone or master/slave mode we strongly advise
you to use the CA-8 "Wired easy controller" or RF-8SET "Wireless
easy controller".
 CA-8 wired remote: Connect the controller to the jack input of
the first unit (master).
 RF-8SET wireless remote: the wireless remote has two parts:
 RF-8T: small RF-transmitter that can control up to 5 effects.
 RF-8R: small RF-receiver that should be connected to the
DIN 5pin input of the projector. See the installation manual
of the receiver for more information.
Now you can control all the connected units:
STANDBY BUTTON:
Press this button to start/stop blackout mode on all connected units.
MODE/FUNCTION BUTTONS:
With the MODE button you can select 3 different modes:
 The LED is off: with the FUNCTION button you can select different strobe modes, like "sound strobe".
 The LED is blinking: with the FUNCTION button you can select different shows.
 The LED is on: (music mode is temporarily switched off)
 Press the FUNCTION button shortly: to change the colors
 Press the FUNCTION button longer: to change the gobos
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit is cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
 Clean the external optics at least once every 30 days.
 Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
JB SYSTEMS
®
10/72 LED VICTORYSCAN MK2 / SPINNER
OPERATION MANUAL